|
The Mittler Brothers Power Drive Bead Roller
…Stop (p/n 200-009). $75.00 Roll Holder (p/n 200-RH). $75.00 Hem Rolls Make edges on rounded or straight edges stronger, safer and more professional in appearance with Hem Rolls. This…
Prices From: $650
|
|
|
Power Drive Rotary Machines
…Step 2 Metal is formed 140 Step 3 Metal is rolled flat Make edges on rounded wheel-well openings as well as straight edges stronger, safer and more professional in appearance with Hem…
Prices From: $135.00
|
|
|
C Cook Pullmax Tooling & Shrinking Dies
…use. Special shanks available. Edge Flanging Dies (p/n Edge Flanging). $595.00 Pullmax adjustable edge flanging die set (2 piece set). Use to turn edges (1/8" - 2") on curved panels,…
Prices From: $695
|
|
|
WiresBead Instructions
…#201-059-S (Male roll on top) To create ΒΌ" long 90-degree flange in metal edge Push metal edge against edge-guide stop in female roll to create 90-degree flange. Hold metal at same angle…
|
|
|
Unibit Step Drills from Irwin
…steel or with TiN (Titanium Nitride) coating for extended edge life. Standard UNIBIT HSS Fractional * Single fluted cutting edge for greater control and rounder holes * Ideal for drilling…
Prices From: $29.94
|
|
|
|
BuildProsLit LQ
…1.04 lbs. T50330 12" x 6" x 2" 11 5" 4.03 lbs. Straight Edge Stops Long slots make these precision machined Straight Edge Stops infinitely adjustable in fixturing applications and…
|
|
|
|
JMRs1005 manual
…tube into die and position as required for start of bend. All bends will start at the edge of the radius die as shown in Figure 2. 6. Install the U strap and snug retainer bolt if…
|
|
|
|
JMRshydraulic
…tube into die and position as required for start of bend. All bends will start at the edge of the radius die as shown in Figure 2. 5. Install the U strap and snug retainer bolt if…
|
|
|
|
JMRsmanual
…tube into die and position as required for start of bend. All bends will start at the edge of the radius die as shown in Figure 2. 6. Under normal use, the pivot bushings should be…
|
|
|
|
JMRsmechanical
…tube into die and position as required for start of bend. All bends will start at the edge of the radius die as shown in Figure 2. 6. Under normal use, the pivot bushings should be…
|
|
|
Jancy Slugger Metal Cutting Chop Saw
…square, and 4-3/4" x 7-1/4" Rectangular capacity * Miters 45 degrees * Leaves material edge straight and clean * Cuts most stainless, aluminum, mild steel material * Eliminates the…
Prices From: $99.95
|
|
|
|
modelsfour
…has been offset drilled to one side as shown in figure 10. The distance from the hole's edge to the pivot block's side will be less than the other three sides. This is the pivot block's…
|
|
